FAQs
KJ.4
Associate III
since ‎2022-12-19
‎2024-01-19

User statistics

  • 29 Posts
  • 0 Solutions
  • 0 Kudos given
  • 1 Kudos received

User Activity

.ELF mismatch issue

2024-01-17
If i compile the same source code in different pcs using same STMCUBE IDE version , Whether i will get same .ELF file?In my case, If i do a comparison(using beyond compare),its not matching and there are significant difference between the two .ELF fi...

Need recommendation for JTAG connection in STM32 MCU

2023-07-14
I am using STM MCU part STM32F303ZET6. Do i need to provide pullup or pull down for JTAG signals? Please help me here with recommendation on which signal to be pulledup or down.Below image is the connection i did for now.please take a look and advise...

I am using crystal resonator part ABC2-8.000MHZ-4-T to supply HSE clock of MC STM32F303ZET6. 1) Is this Feedback resistor(Rf) available inbuilt in MCU? (or) I have to add it ? 2) Can you suggest values of CL1 & CL2? 3) Can you suggest value of Rext?

2023-05-22

Device firmware upgrade pins in STM32F303ZET6 are USART1 (PA9/PA10), USART2 (PA2/PA3) or USB (PA11/PA12).But my external interface is UART. Can i able to configure the USART pins as UART?

2023-04-19

I am planning to use temp sensor part TMP451HQDQWRQ1 with STM32F303ZET6. This sensor is SMBA based. Where to connect SCL & SDA from sensor to MCU? I can see below 4 pins in MCU, I2C2_SMBA I2C3_SMBA I2C1_SMBA I2C2_SMBA Please help.

2023-03-20
View more
Kudos from
View all
Top