Hi,I followed the example for DFSDM found in DM00380469_ENV1.pdf and setup the channels as specified (channel 0/1 -> input from ch1 and internal clock). Cube MX also creates 2 pins , CLK and DATAIN1.STM32F413 MCUIt seems that I cant get any data comi...

Hi,I have a single PDM mic connected to DFSDM2, channel 0 on the NUCLEO. I have configured the peripheral for 16kHz and I have verified that the clock generated is 1MhZ and the mic sends PDM data when clocked.I have checked the signals going to the u...

Hi,I would like to use the SAI as full duplex slave mode with I2S/PCM protocol.I'm not sure about the configuration and which pins are TX and RX when using Cube. In the parameter I can set the audio to transmit or receive.In this case SAI_SD_A will b...