About Patukes

Patukes · 2023-07-12

Hello everyone, I am currently doing a project that requires upto 16384 points of FFT(Fast Fourier Transform) . I found out that I can’t perform this number of FFT points using arm CMSIS DSP library since it is limited to 4096 point Max. Due to this ...

Patukes · 2023-03-21

Patukes · 2021-11-29

Patukes · 2021-11-08

Patukes · 2021-10-22

Patukes · 2023-07-12

@LCE I can't find this memory address in those files . I had increased my heap and stack size as shown in "likage_mem.ng " image.

Patukes · 2023-03-22

Thank you @Community member and @KHALSI_Foued for your answers, I appretiate.

Patukes · 2023-02-09

@TDK Referring to your answer, would't the data truncate to an unit8_t data at the other end. If not, is there any clue on how to recover it properly. Thank you.

Patukes · 2021-12-13

Thank you everyone one for the answers you provided. The major problem was that the micro-controller started with the internal RC oscillator(clock) ; this can't work with USB as USB requires a more stable clock. So I used an external clock.

Patukes · 2021-11-29

This my error messageThis is my error:

User statistics

User Activity

No source available Error

Hi everyone, I have stm32F303re, LQFP64 package. it possible for me to use external SRAM on it?

Hello Everyone, I have implemented FS USB on STM32F303RE nucle board. But I detach the programmer and want to use the STM as a stand lone,Then the usb is not working, I

Hello everyone, I want to to implement amplifier on ADC input in stm32F303RE. I don't have an idea on how to start. Please any useful information will be appreciated. Thank you.

Hello Everyone, Please is it possible to trigger an adc conversion in DMA mode using external interrupt from gpio pin . I am using stm32f303re.

Re: No source available Error

Re: Hi everyone, I have stm32F303re, LQFP64 package. it possible for me to use external SRAM on it?

Re: How to send int values efficiently through CDC USB

Re: Hello Everyone, I have implemented FS USB on STM32F303RE nucle board. But I detach the programmer and want to use the STM as a stand lone,Then the usb is not working, I

Re: Hello Everyone, I have implemented FS USB on STM32F303RE nucle board. But I detach the programmer and want to use the STM as a stand lone,Then the usb is not working, I