FAQs
wild
Associate II
since ‎2018-07-20
‎2023-06-14

User statistics

  • 9 Posts
  • 0 Solutions
  • 0 Kudos given
  • 0 Kudos received

User Activity

VL53L1 erroneously reports valid data for some time after target is removed.

2021-04-02
Greetings.I am using the VL53L1CB and I am seeing it report valid range data when it shouldn’t.I place a target in front of the VL53L1CB and it reports the distance to the target without any problems. However, when I remove the target and the VL53L1C...

arm-none-eabi-gdb.exe has stopped working

2020-12-30
Greetings.I am getting the 'arm-none-eabi-gdb.exe has stopped working' error when trying to debug my project on a Nucleo-F401RE board with STM32CubeIDE 1.5.1 on Windows 10.The problem seems to occur when I enable the I2C3 event and error interrupts i...

How do I read the distance of the closest detected object instead of an average distance of all detected objects with the VL53L1X?

2020-12-18
Greetings.If I point the sensor at a wall and then slowly move my hand into the sensor's viewing area, the sensor gradually changes its reported range from the distance to the wall to the distance to my hand as shown in this graph.Is it possible to s...

Is there a way to detect overflow with LIS2MDL?

2018-06-06
Posted on June 06, 2018 at 19:15GreetingsI am using the LIS2MDL to build a magnetic field sensor for the education market.  When the magnetic field being measured exceeds the maximum allowed value, I notice that the LIS2MDL returns unpredictable dat...

LSM6DS3 gyro data is off by about 15% of what I expect

2016-02-25
Posted on February 25, 2016 at 19:26Greetings.I am trying to get accurate gyro data out of the LSM6DS3, but my results are about 15% off of what I expect.  My test setup is a PASCO scientific Rotary Motion Sensor (RMS) with a LSM6DS3 mounted on top ...
Top