About KSing

KSing · 2019-07-26

In this above situation I am using STM32f105rc microcontroller and uploading code using SWD(Serial Wire Debugger). When I am using utility it gets scanned but when I am trying to upload code from cube ide then It doesn't go on. I don't what settings ...

KSing · 2019-07-14

KSing · 2019-07-14

And also code it accordingly using stm32CubeIDE.

KSing · 2019-07-09

KSing · 2019-07-27

Okay thanks for the reply I will definitely get back to you on this.

KSing · 2019-07-27

Thanx for the reply but actually the issue got solved. Issue was in declaring the crystal oscillator configuration. Earlier I was declaring the HSE to be ceramic/crystal Resonator but I looked up in some of the nucleo boards and found that for HSE I...

KSing · 2019-07-26

Okay, Thanx a lot.

KSing · 2019-07-12

Hi, yeah @hansd56 is saying correct you should try importing through the same procedure. I have tried importing projects from True Studio it just asks for some changes which you need or not it's going to make changes for you on its own.Regards Siin...

KSing · 2019-07-09

@Community member thanks for your reply, I got my problem solved. The problem was we have been using clone chip CSK one's but when I used another company st chips it worked in GDB server mode.

User statistics

User Activity

Hello everyone, have been using chip STM32f105rc and I am not able to access input/ output ports? Help? Thanks in advance.

How to do programming in STM32Cube IDE for using stm32f2105rc MCU in us host mode? Is OTG_FS_ID pin used in only HOST mode operation?

Hello everyone, I am using STM32f105RC for my project in which I have to interface SD Card. But since in datasheet it says can be used. But do I have to use level conversion circuit also? Thanks in advance

Hey newbie, using STM32F103RET6 chip and using STMCubeIDE and it's problematic for me. I have st-link V2 and using it in SWD Mode. But, I'm not able to upload code from STM32CubeIDE. But when I tried it with STM32 utility it gets connected.

Re: How to do programming in STM32Cube IDE for using stm32f2105rc MCU in us host mode? Is OTG_FS_ID pin used in only HOST mode operation?

Re: Hello everyone, have been using chip STM32f105rc and I am not able to access input/ output ports? Help? Thanks in advance.

Re: Hello everyone, I am using STM32f105RC for my project in which I have to interface SD Card. But since in datasheet it says can be used. But do I have to use level conversion circuit also? Thanks in advance

Re: Is there any user manual to import a Keil MDK 5 project to CubeIDE?

Re: Hey newbie, using STM32F103RET6 chip and using STMCubeIDE and it's problematic for me. I have st-link V2 and using it in SWD Mode. But, I'm not able to upload code from STM32CubeIDE. But when I tried it with STM32 utility it gets connected.