Hello everyone, I am using STM32f105RC for my project in which I have to interface SD Card. But since in datasheet it says can be used. But do I have to use level conversion circuit also?
Thanks in advance
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2019-07-14 5:47 AM
And also code it accordingly using stm32CubeIDE.
Labels:
- Labels:
-
SDIO-SDMMC
-
STM32CubeIDE
-
STM32F1 Series
This discussion is locked. Please start a new topic to ask your question.
2 REPLIES 2
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2019-07-14 6:04 AM
The SDIO interface and cards should be fine at 3.0 or 3.3V
For example circuits see EVAL series board schematics.
Tips, Buy me a coffee, or three.. PayPal Venmo
Up vote any posts that you find helpful, it shows what's working..
Up vote any posts that you find helpful, it shows what's working..
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2019-07-26 11:55 PM
Okay, Thanx a lot.
