About SSala.3

SSala.3 · 2024-02-05

Hi All,I have created a copy of an existing CubeIDE project "riverdi-70-stm32h7-lvgl" as you see below. The second project doesn't have the active CM7 project feature that allows to build, it just shows CM7 folder. What is the reason for this? I trie...

SSala.3 · 2022-11-10

Hi all,Is it possible to capture image from an IP camera which is connected to an STM32 MCU via ethernet port? An external RAM can be added to handle the data traffic. Due to multiple reasons I cannot use a digital camera instead of an IP camera.Does...

SSala.3 · 2022-06-09

Hi,I have a custom board with STM32f427VG and KSZ8041NL PHY. My ethernet communication is working well in STMCube IDE 1.8.0. But when I try to configure ethernet in ver:1.9.0 I don't see a input box for PHY address. It says it some ethernet settings ...

SSala.3 · 2022-05-16

Hi all,I am working on a project that transmits UDP packet to a remote IP and port. I need to receive a broadcast packet from a particular source port. Below is my current UDP initialization.I am using LWIP stack for UDP communication. How should I i...

SSala.3 · 2022-04-28

Hello,I am configuring KSZ8863 3 port switch over I2C. And the slave address Read/Write address is oxBF/0xBE respectively. In the HAL reference manual it says the address should be shifted left before calling the interface. It's confusing, if I am sh...

SSala.3 · 2024-02-05

Thanks @Imen.D AN5361 was helpful in resolving my problem.

SSala.3 · 2022-11-15

Hi @Piranha Our project requirement is to capture an image from an IP camera based on some events. At present I'm checking the feasibility of using an MCU based solution. So this is my starting point as I haven't done any image processing projects b...

SSala.3 · 2022-11-14

Thanks for the reply, exploring things makes us experts from beginners... I went through the datasheet of few IP cameras and obviously there was not much information to interface it with an MCU or any other third party hardware. What would be the fir...

SSala.3 · 2022-11-10

@Piranha Hi, is the interface generic to any IP camera? Is there any commands or any specific protocol to fetch the data from an IP camera?

SSala.3 · 2022-04-28

@KnarfB Thank you very much for the clarity.

User statistics

User Activity

Unable to build the imported stm32h7 Dual core project

Interface IP camera with STM32

Ethernet communication not working in ST32Cube IDE 1.9.0

Receive UDP broadcast from a particular source port

How to pass Salve address in HAL_I2C_Master_Transmit ? " The device 7 bits address value in datasheet must be shifted to the left before calling the interface"

Re: Unable to build the imported stm32h7 Dual core project

Re: Interface IP camera with STM32

Re: Interface IP camera with STM32

Re: Interface IP camera with STM32

Re: How to pass Salve address in HAL_I2C_Master_Transmit ? " The device 7 bits address value in datasheet must be shifted to the left before calling the interface"