Hi @LinuxAddict ,
Could you check these different points, please:
Are you sure about the pinctrl you indicated?Are you sure your power supply is correct and properly configured?Are you sure you're on the right channels?
Regards,
Grégory
Hi @LinuxAddict ,
Have you checked the various wiki pages to see if you've missed anything?
https://wiki.st.com/stm32mpu/wiki/ADC_device_tree_configuration
https://wiki.st.com/stm32mpu/wiki/ADC_OpenSTLinux_drivers
Regards,
Grégory
Hi @DEENADHAYALAN,
I see that your binary path points to the fip folder, which does not match what is shown in the Getting Started.Could you try again using this page?
https://wiki.st.com/stm32mpu/wiki/Getting_started/STM32MP1_boards/STM32MP135x...
