About yang2

yang2 · 2025-02-25

Dear All, The IPMlnmx decoder on the STEVAL-IPM30B board—what is its function?I cannot find any relevant documentation about it.Does anyone know? Best Regards,

yang2 · 2025-01-13

Dear all, I am developing motor control system, and would like to observer the (motor) current response. In the past, the method I often used was DAC, where the current command and actual value were output separately through the DAC to an oscillosco...

yang2 · 2024-11-18

Dear All, I want to use STM32CubeMonitor to monitor 64-bit variables, such as int64_t or uint64_t. However, it seems that 64-bit variables cannot be selected from the variable list (they are not displayed).Is there any way to achieve this?Best Regard...

yang2 · 2024-10-24

Dear All,I've been using MCU/DSP-related products for over 10+ years, but I've always had some confusion about clock multipliers and dividers. I'd like to ask for everyone's opinion on this topic.As shown as below figure (it's the clock configuration...

yang2 · 2024-10-16

Dear All,I am developing a motor control system(FOC) with STM32H5.In the FOC process, while completing the ADC conversion for current measurement, it enters the ADC interrupt, where I read the TIM2 counter(for Encoder interface) to obtain rotor angle...

yang2 · 2025-01-14

Hello Andrew,Thank you for your comments.1. The following is my communication protocol. Its packet length is 14 Bytes.(The original data content is 4 bytes, but the entire packet includes SOF, EOF, some CRC, and a device identifier.)Thus, each packe...

yang2 · 2024-10-21

Hello Waclawek,Thanks your opinion, It's good advise to me.I have another ideal, maybe we can use TRGO to trig DMA, and transfer the data from TIM2.CNT to my variables.The advantage is that there's no need to go through capture.(CH3/CH4)It seems like...

yang2 · 2024-10-09

Hi, Stephane, I totally understand via your reply.This is a good explanation. I am very grateful

yang2 · 2024-10-08

Hello TDK, I think what you said makes a lot of sense. It might really be caused by the fact that it's transmitted as two separate bytes. Thank you for sharing your opinion.

yang2 · 2024-10-08

Additionally, if I add monitoring of other values, there is a chance that the data will return to normal.For example, as shown in the image, I added two more monitoring variables, offset[0] and offset[1].At this point, ADCvalue[2] returned to normal....

User statistics

User Activity

What is its function of LNMX decoder on STEVAL-IPM30B board?

Which communication interface is suitable to observer motor current? (fast/real-time )

How to use stm32cubemonitor to observer 64bit length variable ?

The question of setting clock multipliers and dividers

Can we latch encoder timer synchronized current measurement? (STM32H5)

Re: Which communication interface is suitable to observer motor current? (fast/real-time )

Re: Can we latch encoder timer synchronized current measurement? (STM32H5)

Re: The Read Data is always "0" in STM32H5 MCU

Re: The monitored data with "spike"

Re: The monitored data with "spike"