2020-05-22 03:09 AM
Error in final launch sequence:
Failed pre launch
Firmware remoteproc load failed!
CubeIDE has connected to FTDI and has detected the IP address of the board
2020-05-22 08:44 AM
Hello @DShev.1 ,
When setting up the debug session, did you follow these steps?
https://community.st.com/s/question/0D53W000004HK91SAG/how-to-connect-and-debug-cortexa7-cores-on-stm32mp157cdk2
https://wiki.st.com/stm32mpu/wiki/Getting_started/STM32MP1_boards/STM32MP157x-EV1/Develop_on_Arm%C2%AE_Cortex%C2%AE-M4/Modify,_rebuild_and_reload_a_firmware
Hope this helps
BR,
Milan
