STM32CubeProgrammer v2.17.0 release information New features:• Added the support for the STM32MP25xx microprocessors in the STM32MP2 series – Flash memory and OTP programming, SSP support Added the support for devices in the STM32WB0 series: STM32WB0...
STM32CubeProgrammer v2.15.0 release informationNew features:• Added the NOR flash memory and OTP fuse programming via USB and UART using OpenBootloader for the STM32MP13xx microprocessors• Added the support for the PMIC programming via UART for the S...
Hi,Using own custom board based on stm32mp151I'm using STM32CubeProgrammer to program to nand, but I'm getting errorError: ssbl1 (0x6): Bad size for partition 2 (ssbl1) at 0x200000 = 0xfe00000 <> 0x200000 expected my .tsv file is#Opt Id Name Type IP ...
Hello,with CubeMx 6.9.2 i am generating Code for CubeIDE with the goal to figure out which periphery is assigned to the CA7 or the CM4.With Freemarker it is possible to get information about which IP's are assigned and used but i have no idea how to ...
Is there any documentation or guidance on how to configure Yocto to deploy a custom u-boot image? I've been following https://wiki.st.com/stm32mpu/wiki/How_to_configure_U-Boot_for_your_board and https://wiki.stmicroelectronics.cn/stm32mpu/wiki/STM32M...
I debug a simple project STM32MP15 M4 GPIO-EXTI-CM4, using engineering mode. It worked couple days ago. Today when I tried again, I got the error below and it doesn't make sense.
Hi@Olivier GALLIENI have followed the steps in https://wiki.st.com/stm32mpu/wiki/How_to_create_your_own_machine#Generate_device_tree to generate a image for my specific machines dts. But when building the image the error below is generated. I have do...
I’m new for STM products. After some google, I found mp157d-dk1, I want use it to study Linux kernel. Does the onboard STLink support Linux kernel code debug? Like set breakpoints/single step/observe variables values?Another question, is this boards ...
Hello everyone,I've a question. I want to use a Cortex-A7 on STM32MP13x or STM32MP15x for my project and I would like to parallelize my application. Can I use OpenMP on STM32CubeIDE? Is there a difference if I use OpenSTLinux?
CubeIDE coding section part freezes in my second monitor even though I can restart the program from the file top down menu but it's quite annoying. Is there anyone experienced the same issue ? What would your suggestion be to overcome it ?Distro: Ubu...
Hello everybody,currently i am trying to migrate from KEIL uvision to CubeIDE.CubeIDE Version: 1.13.2Build: 18220_20230914_1601Target: STM32MP157Debug Probe: STLink-v3miniE or othersExample Project: OpenAMP_FreeRTOS_echo_CM4 When I start a debug sess...