while i was trying to run example code from cude ide following message popes up what to do ?

[JNAMB.1]

Error in final launch sequence:

Failed to start GDB server

Failed to start GDB server

Error launching GDB server. Session terminated

Cannot run program "C:\ST\ST

[Romain DIELEMAN]

Hi,

Could you give more details on your issue ? What version of CubeIDE are you using ? How did you start your project ? What are you trying to do ?

/Romain

[Romain DIELEMAN]

Hi,

I have found this post on Community that resemble your issue. Does it apply to your scenario ?

/Romain

[JNAMB.1]

yes it helps , i also use avast free anti-virus, thank you

[Romain DIELEMAN]

Did it solve your issue ? If yes could you select the previous message as "Best Answer" so that people facing the same issue will refer to the linked post.

/Romain

[GFrid.2]

Check for proper placement of the target board's power supply jumper, often labeled with selections: E5V, STLK, USB.