Problem with Steval-Spin3202 Board
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2019-10-23 7:24 AM
Hello everybody,
I want to test a BLDC-Motor with the STEVAL-SPIN3202 board and the Motor Control workbench software.
If I start the motor, I always get the message "start up failure" in the monitor of the Motor Control software and the motor doesn't rotate?
Can anybody help me with the settings for a BLDC-Motor in sensorless mode?
Labels:
- Labels:
-
STM32 Motor Control
This discussion is locked. Please start a new topic to ask your question.
2 REPLIES 2
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2019-10-24 12:51 PM
Hi, Google: "STM PMSM FOC SDK FAQ"
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2021-06-21 11:13 PM
The question has been set only to the "STM32 Motor Control" topic (the question is only about the STM32 MC SDK).
Best regards
