Hello
I am new to STM32. I want to Use FOC for controlling sensorless motor. Which MPU/MCU can be used for ESC of drone motor?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2021-10-01 10:56 PM
Hello
I am new to STM32. I want to Use FOC for controlling sensorless motor. Which MPU/MCU can be used for ESC of drone motor. I found STEVAL-ESC001v1 can be used as reference design for entry level commercial drone design.
Which software I need to download and only ordering ESC001v1 will be sufficient to start project? or is there necessity to order other board?
Solved! Go to Solution.
- Labels:
-
STM32 Motor Control
-
STM32G4 Series
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2021-10-03 03:33 AM
You may look at the newer (G4 line) and smaller B-G431B-ESC1 Discovery kit. The free STM32 Motor Control Software Development Kit will get you started to develop a Motor Control project. For a nice 3rd party open-source project, check out VESC.
hth
KnarfB
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2021-10-03 03:33 AM
You may look at the newer (G4 line) and smaller B-G431B-ESC1 Discovery kit. The free STM32 Motor Control Software Development Kit will get you started to develop a Motor Control project. For a nice 3rd party open-source project, check out VESC.
hth
KnarfB
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2021-10-06 12:41 AM
Thank you