STM32C011F6P6 can`t connect to ST-Link Utility

[jeecrnl]

Having trouble connecting to ST-Link Utility. Cannot connect to target keep popping up.

Here is the schematic.

I`m using ST-Link/V2 for programming.

I followed this pinout to connect to the MCU

I connected the following. SWDIO to TP3, SWCLK toTP2, NRST to TP4 then VCC and Ground. I already double check connection and tried different board and I still can`t connect.

[STTwo-32]

Hello @jeecrnl and welcome to the ST Community 😊.

I suggest you to try using the STM32CubeProgrammer since the ST-LINK UTILITY is not recommanded for new designs.

Best Regards.

STTwo-32 

[jeecrnl]

Its having the same problem