cancel
Showing results for 
Search instead for 
Did you mean: 

I don't want to use USB Enumeration as a storage found in PC and want to work with Keil IDE

Sid_C
Associate

 

hi, 

As per the attachment shown, When I connect the Nucleo stm32f411 board, I dont want NOD_F411RE (D:) Drive to come , I just want to see its debugging and upload code interface only with Keil IDE. So need support on how to remove it.

 

 

Thanks,

Sid_C

2 REPLIES 2
TDK
Guru

Do a ST-Link firmware upgrade in STM32CubeProgrammer and change the type to not include the mass storage.

TDK_0-1697808553158.png

 

If you feel a post has answered your question, please click "Accept as Solution".
Billy OWEN
ST Employee

Hi @Sid_C 

 

The forum moderator had marked your post as needing a little more investigation and direct support. An online support case has been created on your behalf, please stand by for just a moment and you will hear from us.

 

Regards,

Billy