Can ST-link V2 programmer Connected to STM32H750VBT6 With 3Pin(SWDIO&SWCLK&GND) and Program it with keiluVisionV5.24a ???

[MFarh]

Hello friends.

I want to program my software to STM32H750VBT6.

i Have a st-link v2 usb programmer with SWDIO pin , SWCLK pin ,RST,SWIM and 3.3V & 5V&GND on it,i connected SWDIO ,SWCLK and GND pins to My MicroController.in Debug Of Keil ( Option and target ) I select STM Debuger.Keil Knows Perogrammer But Can't Find Target.

in Last Version Of CubeMX there is a warning which Explains"This ip has no parameters to be configured !!!"---->SystemCore/SYS setting.

i need your helps.

please help me .How i program this chip whit keil??????Thanks.

[Tesla DeLorean]

Custom board? Does it work anywhere else, like via STM32 Cube Programmer or ST-LINK Utilities? I'd have NRST wired myself, and be using uVision 5.28a​

[MFarh]

• I Designed Shematic and PCB Myself with application Notes and datasheets.
• No , It Doesn't work with uVision and Cube Programmer and ST-link Utility.
• May it works correctly With Uvision5.28a????i believe bit doesn't depend on uVision Version.

[Tesla DeLorean]

Ok, so start by assuming board is nonfunctional, and do basic bring up testing and validation. Start by looking at supplies, idle state of NRST, and VCAP pins.​

[MFarh]

thank you....

i cheked more than 100 times my hardware.

apparently no problem.Vcaps bypassed with 100nF

NRST conected to a pull-up Resistor and bypassed with 100nf.

please send me an empty e-mail i will send back my shematic and software to you.

my mail: Majid_farhangfar@yahoo.com

thank again!!!!