ST7FMC2 MPAR register

andreasfiebich9 · ‎2005-05-25

Posted on May 26, 2005 at 06:05

andreasfiebich9 · ‎2005-05-24

Posted on May 24, 2005 at 10:44

What is the MPAR register used for if DAC=1, DTE=0, PCN=0 ? i.e.

Motor controller in direct access mode, only PWM U signal connected to channel manager, dead time generator disabled !

I just want to control a brushed DC motor (only one direction includind brake) with outputs MC00 (Low side) and MC01 (Highside for braking)

alain2399 · ‎2005-05-25

Posted on May 26, 2005 at 06:05

Your posted your question in the ST6 forum, you should have done it either in the ST7 or motor control one.

Post it again if you want someone to answer.