comunication with Master & Slave on ST7 and ST6

ibb · ‎2004-09-02

Posted on September 03, 2004 at 05:53

ibb · ‎2004-06-13

Posted on June 13, 2004 at 13:04

Hi; on any helps

I search an assembler or ST-Realizer2 application for a ST6265 master

and a ST72331N4 as a slave, I have load same sample (without) an

emulator, but there is no signal.

Have any body thes realize in actual projekt.

The world wait for these application.

Best Regards

[ This message was edited by: Goliath on 14-06-2004 00:34 ]

rene2 · ‎2004-09-02

Posted on September 03, 2004 at 05:53

Hi,

Does your problem still exist?

As a new member on this forum, it's a bit late perhaps but I'd like to point out that you perhaps did not initialize the Slave Select pin on the device.

I know that Actum Solutions provides an application note and Realizer examples with their product. Check on www.actum.com.

Balvie