ST10F276 Flash

mondher · ‎2004-10-14

Posted on October 15, 2004 at 04:43

ST10F276 Flash

mondher · ‎2004-10-14

Posted on October 14, 2004 at 17:49

Hello

I want to program the flash of the ST10F276 using the flash registers, but my problem is that I read in the memory values different of the values that I had written. What could be the problem?

Thanks,

najoua · ‎2004-10-14

Posted on October 15, 2004 at 04:43

Hello,

I had nearly the same problem. The data that you had read may be read from another memory and not from the flash.

Check That :

- ROMEN bit in SYSCON register is set .

- Verify that XFLASHEN bit in XPERCON register is set in order to be able to access the Flash Control Register

I hope this will help you.

[ This message was edited by: Najoua on 15-10-2004 09:31 ]

[ This message was edited by: Najoua on 22-01-2007 11:58 ]