cancel
Showing results for 
Search instead for 
Did you mean: 

Teseo-LIV4F

Aravind
Associate III

Hi team,

    I already have this module-Teseo-LIV3F( https://estore.st.com/en/evb-liv3f-cpn.html ) But i need communicat the L5 band NAVIC signal. In this module not supported the L5 NAVIC signal.

In this module-Teseo-LIV3F( https://estore.st.com/en/evb-liv3f-cpn.html )  replace the L5 NAVIC supported ic a Teseo-LIV4F(https://estore.st.com/en/teseo-liv4ftr-cpn.html)

This is supported or Not???

Thanks and Regards

Aravind.SR

7 REPLIES 7
Francesco Virlinzi
ST Employee

Hi

Hope this clarify

Regards

 Francesco

 

Not sure what the question is. There's an EVB for the Teseo 4

You should contact sales directly via a local representative if appropriate. You could try filing as an Online Support Request via the support portal.

Interest outside India for NAVIC is relatively low, perhaps you have local technology or support that can provide a more timely solution?

Tips, Buy me a coffee, or three.. PayPal Venmo
Up vote any posts that you find helpful, it shows what's working..

https://www.st.com/en/evaluation-tools/evb-liv4f.html

Tips, Buy me a coffee, or three.. PayPal Venmo
Up vote any posts that you find helpful, it shows what's working..

Hi Francesco

              Pls give me the block diagram of (Teseo-LIV3F GNSS module Evaluation Board)

Thanks and Regards

Aravind.SR

Aravind
Associate III

Hi

Yes. Navic can be acquired on EVB-LIV4F.

Again take care you have to install the correct firmware (available on Teseo-LIV4FSW) to support Navic.

Regards

 Francesco