ADC1 and 2 timing longer than data sheet values Hello,I try to setup ADC1 and ADC2, but I don't get the timing values given in reference manual and data sheet. I work with STM32H743 NucleoI have setup RCC to clk ADC with 36 MHz from PLL2P. I checked the frequency at master clock out 2 on PC9. To initialize ADC1 and 2 I use this code:volatile uint32_t wait_cnt;
// ADC init: for ADC1 and ADC2
// reset ADC1 and ADC2:
SetBitMask (RCC->AHB1RSTR, RCC_AHB1RSTR_ADC12RST);
ClearBitMask (RCC->AHB1RSTR, RCC_AHB1RSTR_ADC12RST);
// enable ADC clk
SetBitMask (RCC->AHB1ENR, RCC_AHB1ENR_ADC12EN);
__DSB (); // needs to be here according to errata, to wait till periph clk is enabled
ClearBitMask (ADC1->CR, ADC_CR_DEEPPWD);
ClearBitMask (ADC2->CR, ADC_CR_DEEPPWD);
SetBitMask (ADC1->CR, ADC_CR_ADVREGEN);
SetBitMask (ADC2->CR, ADC_CR_ADVREGEN);
SetPortBit (port_Testpins, pin_ADC_test);
for (wait_cnt = 0; wait_cnt < 500; wait_cnt++)
{ // wait for ADC voltage regulator to stabilize, this loop is c
