Problem with WiFi shield FW

[Paolo Nogara]

Posted on April 18, 2017 at 21:11

Hello everyone,

I have a

problem with

wifi

shield

.

I followed the

'

WiFi-en.DM002450122

'

manual (first file)

to

move the

UART1

from

PA9

and

PA10

to

PB6

and

PB7

(removing

\

shifting

resistors)

,

now I

have

tried to download

the firmware

for the first

configuration of the

shield

,

following the

'X-NUCLEO-IDW01M1- FW upgrading over UART_v1.1'

manual

(second file),

but I have seen

after

that at the end

of

page 11 of

the first

manual

FW

must

be changed.

I know I did

a stupid thing,

but

can anyone help me and tell me

how to change the

FW

?

Thanks in advance,

regards

Paolo

[Imen.D]

Posted on April 18, 2017 at 23:35

Hi

Nogara.Paolo

,

You should to download and install the firmware package relevant to your device as

http://www.st.com/content/st_com/en/products/embedded-software/mcus-embedded-software/stm32-embedded-software/stm32cube-embedded-software/stm32cubef4.html

Imen

[Paolo Nogara]

Posted on April 19, 2017 at 14:12

Hi

@

Imen

D.

,

thanks for the tip

, and

for the link

, but

I still have

problems with

the first configuration

of the

shield

(I can not

communicate with the

shield

to load the

FW

[

I am stuck

on page

5

of the

'

X

-

CORE

-

IDW01M1-

FW

upgrading

over

UART_v1

.

1

'manual

]

)

...

any other suggestions

on

how to fix it

?