Problem with WiFi shield FW
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2017-04-18 12:11 PM
Hello everyone,
I have a
problem with
wifi
shield
.
I followed the
'
WiFi-en.DM002450122
'
manual (first file)
to
move the
UART1
from
PA9
and
PA10
to
PB6
and
PB7
(removing
\
shifting
resistors)
,
now I
have
tried to download
the firmware
for the first
configuration of the
shield
,following the
'X-NUCLEO-IDW01M1- FW upgrading over UART_v1.1'
manual
(second file),
but I have seen
after
that at the end
of
page 11 of
the first
manual
FW
must
be changed.
I know I did
a stupid thing,
but
can anyone help me and tell me
how to change the
FW
?
Thanks in advance,
regards
Paolo
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2017-04-18 02:35 PM
Hi
Nogara.Paolo
,You should to download and install the firmware package relevant to your device as
Imen
Thanks
Imen
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2017-04-19 05:12 AM
Hi
@Imen
D.
,
thanks for the tip
, and
for the link
, but
I still have
problems with
the first configuration
of the
shield
(I can not
communicate with the
shield
to load the
FW
[
I am stuck
on page
5
of the
'
X
-
CORE
-
IDW01M1-
FW
upgrading
over
UART_v1
.
1
'manual
]
)
...
any other suggestions
on
how to fix it
?