About Jeeva

Jeeva · 2024-06-28

I have made my own PCB with STM32F427VIT6 for a project. But if I tried connecting with the cube IDE, I could not connect it through the Type C port, I could only connect it with STlink. Even my laptop doesn't detect the port. Can anyone help debug t...

Jeeva · 2024-06-27

Hello, I have designed my PCB with stm32f427VIT6 and a 24Mhz crystal oscillator. I was trying to upload and test the normal blink code and it's not working. If I disable the external clock, the LED works and does not work with an external clock. I am...

Jeeva · 2024-06-28

I tried the same but it's not working. is there any chance that if the external oscillator does not work USB C also will not work ?. because my oscillator was wrong I have to replace it with a passive one. in my board, I have an active one. will that...

Jeeva · 2024-06-28

I did the same., but its not detecting. can you tell me the sequence ?. first I should make the boot0 high then hard set right ?. I the same

Jeeva · 2024-06-28

I tried uploading the firmware through Type C, but I couldn't so I did it with stlink. my boot0 was high when I tried with type c.

Jeeva · 2024-06-28

Yes I am replacing the oscillator. but I have one more issue my Type C port is not getting detected. is this oscillator could be any reason for that?

Jeeva · 2024-06-28

Thankyou for the response. The issue is with the oscillator only, I chose the wrong one.

User statistics

User Activity

USB type C not working.

External oscillator issue ( stm not booting)

Re: USB type C not working.

Re: USB type C not working.

Re: USB type C not working.

Re: External oscillator issue ( stm not booting)

Re: External oscillator issue ( stm not booting)