About JRAxelrad

JRAxelrad · 2024-08-06

Hello.I'm working on the stm32h753vit6 MCU trying to integrate the X-CUBE-AI software package into my project and I noticed a couple of issues.1) After installing the package, I go into the IOC and as soon as I enable the X-CUBE-AI, the RCC_OSC_OUT p...

JRAxelrad · 2024-04-24

Hello everyone.I'm working on the stm32G474RBT6 MCU and I'm trying to set up both FDCAN1 and FDCAN2 to work simultaneously.I wanted to map the FDCAN1 to RxFIFO0 and the FDCAN2 to RFIFO1. The FDCAN1 work perfectly while the FDCAN2 doesn't seem to get ...

JRAxelrad · 2024-08-07

Thank you very much!That did the trick.

JRAxelrad · 2024-08-07

The changes I'm talking about occur straight away in the IOC as I'm working on it, before even going into the code.This is the RCC definition in the IOC before adding the AI feature:And the clock tree: And these are the clock tree and RCC definitions...

JRAxelrad · 2024-08-07

Thank you for the reply.The changes happen in my case without any prompting (I'm using the stm32CubeIDE version 1.14.0)Also, my MCU was running at 480MHz before adding the X-CUBE-AI and it dropped significantly after the addition.

JRAxelrad · 2024-06-16

Hey.Did you ever end up finding an example implementation for the FDCan on bare metal?

JRAxelrad · 2024-04-24

Thank you @Sarra.S for the quick reply!I thought about this, but I couldn't find a method of properly adding an offset to the message ram property of the FDCAN on the stm32g474 mcu.

User statistics

User Activity

X-CUBE-AI integration and clock errors

STM32g474 fdcan RxFIFO1 issues

Re: X-CUBE-AI integration and clock errors

Re: X-CUBE-AI integration and clock errors

Re: X-CUBE-AI integration and clock errors

Re: Bare Metal FDCAN on STM32G491

Re: STM32g474 fdcan RxFIFO1 issues