About Amit_Korgaonkar

Amit_Korgaonkar · 2024-06-12

11:15:51 : UR connection mode is defined with the HWrst reset mode11:15:52 : ST-LINK SN : 54FF6C06758351563012188111:15:52 : ST-LINK FW : V2J43S711:15:52 : Board : --11:15:52 : Voltage : 3.25V11:15:52 : SWD freq : 4000 KHz11:15:52 : Connect mode: Hot...

Amit_Korgaonkar · 2024-02-20

Hello STM Community,We are currently engaged in the development of a Battery Management System (BMS) and have chosen the Texas Instruments Bq79652 Q1 IC for sensing voltage, current, and balancing cell voltages. This IC communicates via UART from the...

Amit_Korgaonkar · 2024-08-02

Hello,Did anybody managed to solve this?any solution for this or any idea about doing this right , could really be a big help to us.

Amit_Korgaonkar · 2024-07-30

hello,I have this similar problem but only for one channel.Channel 1 -- Connected to PA4 pin gives the inverted output , but the Channel 2 -- connected to PA5 pin give correct output.Currently I have only one board for testing.So if the DAC is damage...

Amit_Korgaonkar · 2024-06-13

The board I am using is STM32F765VIT6 We have done this hardware setup referring to one of the documents .Application note AN4661It also has boot 0 and boot 1.We are making use of boot0 in our implementation. Will check again.Thanks.

Amit_Korgaonkar · 2024-02-21

Could ST recommend a suitable MCU family for our use?

User statistics

User Activity

Option Byte failed during connection of MCU

Help Needed in Selecting MCU for Efficient Battery Management System (BMS)

Re: STM32L562-DK STMCubeProgrammer-Error:Initializing the option bytes failed Error: Uploading option bytes bank:0 failed.. How to recover the b

Re: My DAC outputs inverted values (0000 = 3.3V and 4095 = 0V)

Re: Option Byte failed during connection of MCU

Re: Help Needed in Selecting MCU for Efficient Battery Management System (BMS)