About ItzSam

ItzSam · 2024-05-21

Hello everyone,I am currently working on a project involving an Evspin32G4-Dual Board, equipped with two brushless motors (Hover Board motors 36V-10A-500 rpm-Hall Sensors).I have completed profiling the motors and their hall sensors using MC Workben...

ItzSam · 2024-02-14

Hello,I have an EVSPIN32G4-Dual, I am Trying to Run 2 HooverBoard Motors (36V/15A/510RPM/HALL).I generated the firmware using Mc Workbench 6.2.1 and desabled the overcurrent protection for stage 2. Then tried to command the motors using motor pilot, ...

ItzSam · 2024-01-19

Hello All,I just Bought an Evespin32G4 dual Board.https://www.st.com/en/evaluation-tools/evspin32g4-dual.html I completed the configuration using the X-CUBE-MCSDK-6.Goal: I will command 2 motors 36V, 4A (Moteur Hoverboard)I generated the cube ide pro...

ItzSam · 2024-05-17

Hello,Thank you. I have read the release notes and saw that you took it into consideration. I tested version 6.3.0, and it works now.Best regards.

ItzSam · 2024-02-13

Hello and thank you for your reply,Sorry, but I am not able to run both motors on the EVSPING4-Dual, for now I have a problem linked to the overcurrent with the same behavior the first motor starts fine when I try to start the second either one of th...

ItzSam · 2024-02-09

hey,sorry for the delay,i just tested the project i just call mc_startMotor1 ()then i call mc_startMotor2 ()just one of them turn this is a screenShot of the handler of the 2 motors as you can see the state of the first motor is RUN, and the other is...

User statistics

User Activity

Evspin32G4-Dual Tuning Speed Control

Evspin32G4-dual : Turning 2 motors simultaneously

Evspin32G4 - dual

Re: Evspin32G4 - dual

Re: Evspin32G4 - dual

Re: Evspin32G4 - dual