About Hammy

Hammy · 2023-06-05

I have integrated Micro-ROS into the m4. I have it working such that I am able to publish sensor data and receive it from other nodes. However Micro-ROS takes up a quite a bit of space, 70+ KB. In their documentation it is target at mid tier micro co...

Hammy · 2023-01-31

I want to be able to have the Ethernet port on my board be configured as a link local address and be able to receive DHCP. How can I accomplish this?

Hammy · 2023-01-26

How do I change the pin for the u-boot-stm32mp programmer mode at boot up?

Hammy · 2023-01-24

There seems to be an issue with CubeProgrammer and parsing hex strings that are longer than 8 characters. For example, an offset of 0x05984400 will parse correctly but 0x105984400 will not. It will incorrectly parse as 0x05984400. I am trying to refe...

Hammy · 2023-01-23

I want to create my own distro for OpenSTLinux but it seems like the envsetup.sh file is dependent on the distro.conf file being located in the meta-st directory. This is a little hard because I am trying to not modify the meta-st layer but am trying...

Hammy · 2023-06-08

Hi @PatrickF Thank you for that information  That looks like the solution to my problem. I will try to adjust the sizing to fit my project. If it works and eventually I want to publish my results as a guide / demo project so other people can get Mi...

Hammy · 2023-04-27

In my case on windows it was located at C:\ST\STM32CubeIDE_1.12.0\STM32CubeIDE\plugins\com.st.stm32cube.ide.mcu.externaltools.openocd.win32_2.2.300.202301161003\tools\bin\openocd.exe

Hammy · 2023-02-07

Try reading and adapting this patch file. It is needed when you remove CONFIG_ENV_IS_NOWHERE=y from the u-boot defconfighttps://github.com/mendersoftware/meta-mender-community/blob/thud/meta-mender-st-stm32mp/recipes-bsp/u-boot/u-boot-stm32mp-2018.11...

Hammy · 2023-02-02

Hi @Bernard PUEL I am using Ubuntu 20.04.Also another data point. I tried to work around the issue by using a GPT image but that didn't seem to work either. When I went to flash the device I used the following.#Opt Id Name Type IP Offset Binary - 0x...

Hammy · 2023-02-01

Hi @Bernard PUEL ,Awesome! Glad to hear that. What did your TSV look like? When I did this, I had an error thrown that there were two partitions with the same location. Were you able to validate the partition layout was correct after flashing? I thi...

User statistics

User Activity

Possible / advisable to increase the size of m4 coprocessor text and data size?

How to configure ethernet port for direct connect and DHCP

How to change the pin that is used for the u-boot programming mode

Cube Programmer can't handle numbers larger than 32 bits in the offset field

OpenST creating your own distro - envsetup.sh can't find distro.conf in other layers

Re: Possible / advisable to increase the size of m4 coprocessor text and data size?

Re: STM32CubeIDE Cannot run program "gdb": Launching failed

Re: STM32MP1 boot stuck on SP_MIN: Preparing exit to normal world

Re: Cube Programmer can't handle numbers larger than 32 bits in the offset field

Re: Cube Programmer can't handle numbers larger than 32 bits in the offset field