About Anil3

Anil3 · 2024-09-02

Hello everyone!!!By using STM32F401CCU6 controller boot pind and trying to flash my program through UART, for that i have made the Boot_pin0 to high and Boot_pin1 to low and reset the controller later trying to connect with STCube programmer via UART...

Anil3 · 2024-08-02

Hello Everyone!I am using ISM303DAC sensor in my project and facing an issue with Pitch value. I have used MotionMC library and calibrated the Magnetometer for heading. and also it got calibrated. As MotionEC_Run() function output consists of Euler...

Anil3 · 2024-07-15

Hi everyone!!!i am working on motionEC library and there i have observed that it need sensor orientation. can anyone explain me what exactly is this orientation meaning and how it effects the library??reagards,regards,ANIL.

Anil3 · 2024-07-03

Hi!!!I am want to implement Emulation of EEPROM for STM32F401CCU6 Controller which is having 256kb of flash memory. but not sure of how exactly that i have to use it. I have downloaded X-CUBE-EEPROM software but in that there is no any project relate...

Anil3 · 2024-07-02

Hello Everyone!!!I am using STM32F401CBU6 controller along with 2 sensors ie., (ISM330DLC & ISM303DAC) in my project. I have included motionfx library and getting Roll, Pitch, Yaw and Heading, but the heading is not getting calibrated and values are ...

Anil3 · 2024-09-02

@MM..1 Actually it is mentioned for UART2 Pins are PD5,PD6 but for the controller (STM32F401CCU6) 48 pin package these pins are not avilable instead i have seleted the default pins for UART which are PA2,PA3. I am using USB-UART bridge.

Anil3 · 2024-09-02

@Tesla DeLorean Thanks for your reply..What else is connected to the MCU? - I haven't connected any other device except RS232.It's a one-shot deal, reset and try over if the connection fails at the first attempt. - I have tried for plenty of times bu...

Anil3 · 2024-08-30

Hi @hexfet13 e I am trying to implement custom bootloader for the same controller (STM32F401CCU6) as i am new to bootloader i am struggling with the concepts and the way of implemetation. if you don't mind could you please share me your bootloader co...

Anil3 · 2024-07-19

Hi @Federica Bossi Sorry for the late reply as i am being on another task i haven't seen into this for a while.I am already using the motionMC library and i am also getting output values with an accuracy of 0.5 degree.In manual it is mentioned that h...

Anil3 · 2024-07-11

Hello @Federica Bossi sorry for the delay in reply as i have assigned in another task i haven't gone through this...As said by you i am using the motionMC library and magnetometer is also getting calibrated.....but i have observed that we are callin...

User statistics

User Activity

Issue with system memory bootloader

Roll value changes with Pitch

clarification regarding sensor orientation

STM32F401CCU6 EEPROM Emulation

MotionFx Magnetometer calibration issue

Re: Issue with system memory bootloader

Re: Issue with system memory bootloader

Re: STM32F401CC bootloader problem

Re: Hard Iron Calibration

Re: Hard Iron Calibration