About SidPrice

SidPrice · 2024-07-25

I have an STM32L433 that implements a SPI slave, it is connected to another MCU master. It is unclear from the datasheet and searches for answers whether MISO and MOSI on the slave should connect directly to MISO and MOSI on the master, or, if they s...

SidPrice · 2024-03-16

I have an issue with adding files to a project I have using the STM32 VSCode extension. I have been working on this project for some time without issue. However, today I needed to add a new source file, I opened STM32CubeIDE and added the source file...

SidPrice · 2024-01-18

I am developing a custom bootloader for a client on an STM32 system. I am using STM32CubeProgrammer to exercise the new bootloader and the built-in system bootloader to investigate the protocol being used over UART. In addition, I am referring to AN ...

SidPrice · 2024-01-16

Hello, I have been using the VSCode STM32 extension on my project for some time and it has been working well. Today, I was doing some major refactoring of some of the code, and this required deleting one of the files no longer required. Unfortunately...

SidPrice · 2023-10-30

I am trying to use one of the STM32G examples for a USB device. The example is for STM32G474-EVAL and I would like to try it on Nucleo-G431KB.Following the instructions I found I have created a new CubeMX project, I did NOT make any changes to the co...

SidPrice · 2024-07-25

@Andrew Neil Thank you, I missed that in the TRM.I think I should be able to put Master MISO on PA6 of the slave and master MOSI on PA7.Again, thanks for the prompt input :beaming_face_with_smiling_eyes:

SidPrice · 2024-07-25

Thank you, yes, I fully understand that. Perhaps I should have been more specific.I am concerned about the connections on the STM32L4. PA6 is SPI1 MISO, PA7 is SPI1 MOSI. So, when the L4 is a slave, the master MOSI is connected to PA6 or PA7.

SidPrice · 2024-03-17

It seems my computer just needed to be restarted, when I powered up today and opened my project the squiggly line had gone, and IntelliSense was also working.Going to mark this as (accidentally) resolved :)

SidPrice · 2024-01-18

That would make sense and I assume the unknown byte #5 is the page number of that second page ... I will proceed based upon that assumption. Maybe ST can comment on this to confirm.

SidPrice · 2024-01-16

@TDK The copyright shown by the extension is ST MicroElectronics, with a link to st.com!Sid

User statistics

User Activity

Connections for STM32L4 SPI slave

Problem with STM32 VSCode Extension

STM32 system bootloader UART protocol

Issue with ST VSCode STM32 extension.

CubeMX file import disabled

Re: Connections for STM32L4 SPI slave

Re: Connections for STM32L4 SPI slave

Re: Problem with STM32 VSCode Extension

Re: STM32 system bootloader UART protocol

Re: Issue with ST VSCode STM32 extension.