I don't know if this is the right place, but I am from the SimpleFOC community, a community slowly developing well engineered modules to build brushless motor drivers with.  Both hardware boards and firmware modules.We have already converged on using...

I have, after overcoming many hurdles, finally succeeded in getting the motor to spin up and be profiled. I didn't really need the profiling information as I already had the motor characteristics, however it helps as a double check. The thing is, n...

The motor pilot connects ok. It tries to start the motor but fails. I think maybe the parameters that are used by the configurator are not what is indicated, for example the resistance could be phase to phase or lead to lead. Same with inductance ...

I'm trying to get a working motor controller out of this toolchain. I apologize that I know very little about C and embedded development, although I have used arduino, I usually use Micropython. I'm sure the answer to this is painfully obvious to ...