About NAdim.1

NAdim.1 · 2024-06-27

Hi All,I'm working on stm32g070rbt6 controller, for vending project.For some requirement implemented PWM timer(i.e. TIM1 & Channel 2) to run the dc motor(i.e. 24V). based on the input from keypad.PWM implemented with soft start from 0 to 1800 which i...

NAdim.1 · 2024-01-17

Hello All,I am working on project using STM32Cube IDERecently I'm facing an issue like everything is working, when it is in debug mode.But when I disconnect the st-link nothing is working.And the project is in end stage and all of sudden I'm facing t...

NAdim.1 · 2023-12-20

I am using stm32g070rbt6 controller for my project, with 16MHz clock.Peripherals included in my project,1.UART2.I2C3.TIMERS(tim14 & tim17)Issue is like when I'm in debug mode, I couldn't able to go step by step code but when I put the breakpoint afte...

NAdim.1 · 2023-06-12

I am using stm32g070rbt6 controller (32Mhz) and communicating with 16x2 LCD in 4-bit mode, Issue we are getting is in between the operation once in may be 2 to 3 hours, all of sudden LCD will get blank continuously, it'll come back to normal only aft...

NAdim.1 · 2023-06-06

NAdim.1 · 2024-06-27

We couldn't be able to check with debugger for long time because the issue will not come frequently and cross verified the pin nowhere it is configured except for timer (Tim1).

NAdim.1 · 2023-12-20

Hello Sarra,Thank you for giving reply,Below is the optimization level of the project

NAdim.1 · 2023-06-13

HD44780...

NAdim.1 · 2023-06-06

The current controller (STM32F070F6P6) we are using eeprom emulation concept for our project. Due to controller unavailability, we changed the controller to (STM32L010F4P6).In the new controller we don't want to change any program and all. So, we wan...

NAdim.1 · 2023-05-24

Thank You, I tried eeprom emulation concept and it helps for my project.

User statistics

User Activity

PWM Timer Issue in stm32go70rbt6 controller

Code is working when it is in debug mode, but once disconnect the st-link nothing is working

Program stuck Thread #1(User request), while debugging

16x2 LCD is getting blank in between the operation once in a while, then system restart required

Is EEPROM Emulation concept will support STM32L010F4P6 Controller?If Yes, how to configure and use for my project.If No, suggest any alternate solution.Thanks,Nikhil

Re: PWM Timer Issue in stm32go70rbt6 controller

Re: Program stuck Thread #1(User request), while debugging

Re: I am using 16x2 lcd with 32MHz frequency for my project but facing an issue like in between the

Re: Is EEPROM Emulation concept will support STM32L010F4P6 Controller? If Yes, how to configure and use for my project. If No, suggest any alternate solution. Thanks, Nikhil

Re: I am using the STM32F070P6, My requirement is small amount of data need to store in internal flash. Can i store the data even after the limitation of flash life cycle? if we cant, is there any better suggestions to over come this problem Thanks, Nikhil