About MSierraA

MSierraA · 2022-02-21

Hello Community,We have been using the IIS3DWBTR sensor for some time and have observed some odd behavior regarding filters. We recently performed some experimental tests on the LPF2 Filter to corroborate the frequency response curves on page 20 of t...

MSierraA · 2022-01-14

Hi Community,We have the IIS3DWBTR, we made a configuration like the following:spi_buffer[1] = 0x06; //power down mode + LPF2 Enable +- 16g spi_write(CTRL1_XL, 1); spi_buffer[1] = 0x44; // bdu: 1, if_inc: 1 spi_write(CTRL3...

MSierraA · 2021-04-12

Hi Community,We send to manufacturing PCB to our supplier but he has a problem with the mark(attached) of the sensor IIS3DWBTR, and we want know if the brand is correct for component, we try to read the image as Qr Code and result is 780270TU01RY, bu...

MSierraA · 2022-03-08

@Eleon BORLINI thank for you answer.Might it be caused by a true mechanical resonance due to spurious vibration of the setup?it is possible in 1KHz but other frequency is rare.Are you using the STEVAL-MKI208V1K to run these measures?we don't use it,...

MSierraA · 2021-04-13

Thank so much @Eleon BORLINI we will tell our supplier

MSierraA · 2021-04-12

Thanks @niccolo.ruffini but the problem is, in this case, i'm in chile and our supplier in other country then i can't test the WHO_AM_I register with the sensor, so the question is how can I tell if the sensor is correct only with the information pr...

User statistics

User Activity

IIS3DWBTR Filter LPF2 frecuency response

ODR vs Interruption signal IIS3DWBTR

How is marked IIS3DWBTR?

Re: IIS3DWBTR Filter LPF2 frecuency response

Re: How is marked IIS3DWBTR?

Re: How is marked IIS3DWBTR?