About MRahi.3

MRahi.3 · 2022-03-04

Hello,I am working on a motor control project. The position feedback is given by a motor resolver.The issue is that I cannot find the option for a resolver in the Motor Control Workbench, only Hall sensors or Encoder. Is there any way to go past this...

MRahi.3 · 2022-03-01

MRahi.3 · 2021-06-08

Hello, I am currently trying to program an STEVAL-ESC001v1 board with an STLINK V2 ISOL probe. The IDE I use is the STM32CubeIDE. Before that, I used a regular STLINK V2 probe and the debugging of my program worked perfectly. Ever since I switched to...

MRahi.3 · 2022-03-02

Ok great, thanks !

MRahi.3 · 2022-03-02

Is the Hall effect drive mode also usable with an FOC algorithm to pilot the motor ? Or is a 6-step algorithm needed ?

MRahi.3 · 2022-03-02

Thank you for your answer

MRahi.3 · 2021-06-08

Hello, I hope someone had an answer to this problem since it was posted a year ago. I am currently trying to program an STEVAL-ESC001v1 board with an STLINK V2 ISOL probe. The IDE I use is the STM32CubeIDE. Before that, I used a regular STLINK V2 pro...

User statistics

User Activity

Motor control with a resolver, using either STEVAL-ESC001V1 or B-G431B-ESC1 and the MCSDK

Hello, I am using the STEVAL-ESC001v1 board with a BLDC motor. I would like to use the Hall sensor mode but I cannot access the pin selection for the Hall sensors in the MC Workbench Does anyone have an idea on how to solve this issue ? Thank you.

STM32CubeIDE debugging problem : Error in final launch sequence

Re: Hello, I am using the STEVAL-ESC001v1 board with a BLDC motor. I would like to use the Hall sensor mode but I cannot access the pin selection for the Hall sensors in the MC Workbench Does anyone have an idea on how to solve this issue ? Thank you.

Re: Hello, I am using the STEVAL-ESC001v1 board with a BLDC motor. I would like to use the Hall sensor mode but I cannot access the pin selection for the Hall sensors in the MC Workbench Does anyone have an idea on how to solve this issue ? Thank you.

Re: Hello, I am using the STEVAL-ESC001v1 board with a BLDC motor. I would like to use the Hall sensor mode but I cannot access the pin selection for the Hall sensors in the MC Workbench Does anyone have an idea on how to solve this issue ? Thank you.

Re: Failed to execute MI command