Posted on October 11, 2017 at 15:23I use a BLDC motor with Hall-sensors and ST FOC 4.3 (STSPIN32F0).  Everything works fine, but when I want to use speed ramps, speed just do not change. The software indicates correct speed ramp, but instead, nothin...

Posted on October 04, 2017 at 13:09Hi!I am using FOC 4.3 with a NovoMotec 1 pole BLDC motor. I can not start the motor at all. The PWM -s are working, and the motor vibrates, but the PWM signals have bad timing, thus braking the motor all the time. ...

Posted on August 09, 2017 at 13:44Hi. I am using MCWB with FOC 4.3. with STSPIN32F0 eval board. I am trying to switch on the bus voltage sensing. When I set it in the WB, compile and upload, it always randomly pops under or overvoltage error. I can ...

Posted on July 31, 2017 at 12:47I am using STSPIN32F0, wich has a maximum of 12kHz FOC freq. I am trying to drive a novoMotec motor, with the attached properties. Since the FOC FAQ states that 'In the case of either a high-speed or low-inductance mo...

Posted on July 14, 2017 at 15:32I am using the Motor Control Library, to control a BLDC motor with Hall sensors. I would like to use the uart for my own purposes. If I enable uart, it dumps trash (since it tries to communicate with the MC workbench)...