About NDagn.1

NDagn.1 · 2025-01-08

Hi,In CubeIDE, new project, choosing STM32H755ZIT6 (the NUCLEO-H755ZI-Q), the board stops responding when turning off and on the power to the board. I have made a simple LED example with everything set to default with the addition of two user LEDs bl...

NDagn.1 · 2021-01-29

NDagn.1 · 2025-01-09

Thank you very much for the good explanation and the solution. I went into Project->Properties->C/C++ Build->Settings and deleted the definition of USE_PWR_LDO_SUPPLY as you explained and everything works again. I will remember to delete the definiti...

NDagn.1 · 2025-01-08

Additional info: Everything works when using older software releases - I can power cycle the board as much as I like and the program runs every time with the LEDs blinking.With these software releases, everything works:STM32Cube Version: 1.16.1CubeMX...

User statistics

User Activity

Default settings for NUCLEO-H755 not working after power off

For seat reservation: I already have the board. I also wrote an email to: tilen.majerle@st.com

Re: Default settings for NUCLEO-H755 not working after power off

Re: Default settings for NUCLEO-H755 not working after power off