About c_dev05

c_dev05 · 2025-01-10

Hello,[VERSION]: 6.3.2[TOOL]: Board Designer, MC WorkBench[DETAILS]: I created a custom board, created a new project and generated the code. All fine.I opened Board Designer and changed the crystal frequency on the board. I saved board Json file.I op...

c_dev05 · 2025-01-09

Hello,in file RegListSTMV2.json I can define custom registers. Most registers have "UpdateFrequency" configured to "MediumFreq".How often is "MediumFreq" polled by Motor Pilot?Is it possible to configure the polling frequency in Motor Pilot?Thanks,

c_dev05 · 2024-10-04

Hello, I am using MCSDK_v6.3.1 and encountered a problem when changing TIM1 PWM pins:I cloned B-G431B-ESC1 Devkit Inverter.I changed High Side TIM1 PWM pinsUH: PA8 -> PC2VH: PA9 -> PC1WH: PA10 -> PC0When I now want to create a project with the modifi...

c_dev05 · 2023-09-26

Hallo,is it possible on any STM32U5 device to write only a SPI or other serial stream, that sends data on rising and falling edge?best regards

c_dev05 · 2021-12-15

Hello,the STM32CubeMonitor-Power is a very useful tool and I am using it a lot.For power optimizing applications often the period, at which current pulses occur, help a lot to find the source. Therefore I am missing a "Cursor" feature for this tool.W...

c_dev05 · 2024-10-08

Hello,I have the same question. Since the accepted solution is already quite old I ask again for usage with MCSDK v6.3.1:Do I have to manually change the generated code?Can I use BoardDesigner?Can I also free PB1? It is not connected on the board.Bes...

c_dev05 · 2024-10-04

Solved. I mixed up PC0 and PC2.Thanks,

c_dev05 · 2023-09-27

I want to use the MDF filter, but unfortunately there is no register for writing the input data by CPU anymore, as it was at DFSDM. So I am looking for a workaround by using the SITF filters connected to SPI.MDF filter documentation writes: For all ...

c_dev05 · 2023-09-26

Thank you for the ideas so far.I want to generate a signal as it is typically sent by stereo microphones. rising edge: bit of left channelfalling edge: bit of right channelWP

c_dev05 · 2021-10-14

I found the solution by analyzing the schematic.External current measurement:connect USB cable to CN16open JP2; onboard MCU not suppliedclose JP7; supply CN20 external supply connectorconnect external device to CN20; pins 1 (GND) und 3 (3.3V or 1.8V ...

User statistics

User Activity

Custom Board changes not considered during MC Workbench Project Generate

MediumFreq Register Update Frequency

Remap PWM Pins

SPI write data at rising and falling edge

STM32CubeMonitor-Power Feature Request

Re: Use MotorControl on B-G431B-ESC1 without using 3 output pins for OPAMP1,2,3 (possible to use interval route to ADC?)

Re: Remap PWM Pins

Re: SPI write data at rising and falling edge

Re: SPI write data at rising and falling edge

Re: Current measurement with STM32L562QE-DK