I've searched through the internet but i'm not able to find any firmware or source for coding the STWBC, atleast a few examples on how to do it. STM provides a binary as firmware to download and use it directly on the evaluation board. But i want to ...

I'm trying to use the Led strip w2812b for a project because i want to add it to an existing project, the support for the arduino is very good and since my code is already in stm32cubeide i cant port to arduino ide. Is there any way to use the FastLE...

I tried to run it but LD7 which is below USB fault lights upAnd i think there is too much current taken from the USB which lights LD7 redI reduced it to 15 GPIO output pins and its fine nowWorks goodBut my project requires the use of around 70 pins

ST890 current limiter on the STM32F767 gets very hot when i connect the USB to STLink to power the MCU. But the overcurrent LED LD5 lights up RED. And no power is sent to the MCU and nothing works, just the ST890 gets very hot.How do i fix this?