Hi,I'm trying to certified a product and we just fail the ETSI EMC. It appears that the USB lines are the cause of this failure. As we tried to track down the main source of this issue it appears that between 2 differents firmware the noise level was...

Hi I'm trying to configure my project with STM32CubeIde 1.2.1I want to use ADC1 to perform temperature and vrefint measurement. So I configure my adc & dma :But I'm not enable in cube to enable the DMA option, only disable is possible. If I enable th...

HiSo I''m trying to use the internal temperature sensor to get a rough idea of the temperature. So first I test it on the NUCLEO-F446 and get good result but when I try to use the same code on my board, I get wrong data. Good data is adc value aroud ...