About Per4

Per4 · 2021-12-02

Hi everyone, Any of you experienced this strange behavour posted yesterday (see below)? It seems to happen to just one of my projects, and not all of the source files are affected (but still a substantial number of files). Any thoughts and experien...

Per4 · 2021-10-27

I'm using the ST32F4 discovery board, and would glad if someone could explain the relationship between the PLLI2S Clock setup in CubeIDE and the actual I2S2_CK (PB10) to the mems mic. I my case I use PLLN=192 and PLLR=3 giving 64MHz I2S Clocks. ...

Per4 · 2021-09-06

Per4 · 2022-01-01

I turned off network connections and generated code without any duplicates. This points in the direction mentioned in my above reply.

Per4 · 2021-12-31

I have exactly the same problem, and spend a lot of time cleaning up HAL duplicates each time I generate code. I use the STM32CubeIDE version 1.8 on MacOS. See my post here: https://community.st.com/s/question/0D53W00001EgOM8SAN/files-left-over-from-...

Per4 · 2021-10-27

Thank you Jan. This was a very helpful and good explanation.

User statistics

User Activity

Files left over from code geneation in StmCubIde

Relationship between I2S Clock setup in CubeIDE and actual I2S2_CK (PB10).

Is it possible to set up the editor to highlight the "USER CODE BEGIN" and "USER CODE END" comments? That would make it more convenient to quickly see the user code blocks and distinguish them from other code comments.

Re: Why does CubeProgrammer often duplicate HAL drivers?

Re: Why does CubeProgrammer often duplicate HAL drivers?

Re: Relationship between I2S Clock setup in CubeIDE and actual I2S2_CK (PB10).