About chrisnielsen9

chrisnielsen9 · 2017-10-04

Posted on October 04, 2017 at 19:31Our application (SensorTile L476) works well when programmed and run from our SWD programmer (Nucleo 476). However, once untethered from SWD, if we disconnect and reconnect the battery, the CPU stays in Reset and ...

chrisnielsen9 · 2012-07-31

Posted on July 31, 2012 at 15:54I'm confused about which firmware code base to use for the start of development: (ZIP files) STM32F4-Discovery_FW_V1.1.0 or STM32F4xx_DSP_StdPeriph_Lib_V1.0.1 They appear to overlap in many areas. What is the intende...

chrisnielsen9 · 2017-10-04

Posted on October 04, 2017 at 22:40I think I figured it out. Our app starts at 08004000, but I did a memory dump back to 0x00000000. My bad, I think. It appears that 'Run Application' loads the low FLASH with vectors and run-time code (I think) -...

chrisnielsen9 · 2017-10-04

Posted on October 04, 2017 at 22:26I watched the ST video on Option Bytes via the Utility. I inspected the Option Bytes (at least those shown by ST-Link) and they are IDENTICAL between my failing board (hung in reset) and my successful board (boots...

User statistics

User Activity

ST-Link Utility ''Run Application'' from CLI?

Which Firmware: Discovery or StdPeriph?

Re: ST-Link Utility ''Run Application'' from CLI?

Re: ST-Link Utility ''Run Application'' from CLI?