Hello,Using a STM32H743ZI - rev. V.I'm using ADC3 to convert 4 channels in regular conversion mode, with a 2.5Tcy sampling time, 10 bits, sync clock /2.The measured conversion time is quicker than expected so I'm suspecting something wrong...CPU cloc...

Hello,I have the tiny STUSB4500 kit (EVAL-SCS001V1), the nucleo + GUI for NVM programming, and the STM32G071B-DISCO packaged kit.I plugged the kit (as a port capacities reader) on 3 Dell laptops. According to the ST kit the laptops are:Compatible to ...

Hello,Using the 48-pin variant (STM32F303CB), the "analog input and protection" pin mapper propose inputs that doesn't exist on the chip (C-port) and doesn't propose available pin (A1, A2, A3...)Any workaround?Thank you

Hi,I installed the motor control software (5.4.1) on my computer and start my design for STM32G4. After code generation, I have numerous motor related file in the scr/ and inc/ directories but they are all empty (they only contain the classical ST he...

Posted on July 12, 2018 at 11:32I have an old version of the st link utility and I have to upgrade it in order to program new STM32H7xx devices.Removing the old version with the windows tool crashed.Installing the new one crash again : 1/ 'Setup cou...