Total newby here- have to debug a digital audio amp using ST-LINK V2. Can someone tell me what cables should have come with this equipment? All I have is the ribbon -> data. I am figuring I need ano9ther cable to provide voltage, is this correct?
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
2021-06-02 11:29 AM
1 REPLY 1
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
2021-06-04 12:47 AM
Assuming the audio amplifier uses a STM8, you need a SWIM cable that runs from the top of the ST-Link to the amplifier. The voltage on the MCU is sensed by the ST-Link, it uses the power from the USB port. The ribbon cable probably is to connect the ST-Link to a STM32 MCU (JTAG)