STM32CubeIDE problem SWD to print in the console, "start trace"
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
2024-10-02 03:43 PM
Good morning everybody,
I try to print in the console by using a ST-link 2 with SWD howerver I can't do it. I watached these 2 videos : https://www.youtube.com/watch?v=sPzQ5CniWtw & https://www.youtube.com/watch?v=JqrUAzjJ0tw
However I still can do it. My problem is when I press the "start race", it becomes red, but when I resume in the debugger, the red light disapears. Thanks in advance
Here the different parameters that I put.
1 REPLY 1
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
2024-10-02 03:45 PM