Good afternoon....
I am new to STM and BLE. I have a while loop in main where I am checking conditional flags that could have been set in IRQs. All seems to work nicely. I then begin the process of implementing the BLE stack for peripheral. After watching a few videos I configured via CubeMX BLE. I am finding that after I implement this my other code stops working. I found that if I comment out MX_APPE_Process(); in the while loop in main all works again. So it appears to me that this process has it's own 'forever' type loop that never leaves once it goes here. Can someone point me to information that may explain how to add my flags into the sequencer piece of the puzzle as this seems like the path I might have to go??? Unless someone has some suggestions on how to do this? I know very little with BLE code implementation so I appreciate any pointers.
Thanks
