stm32f4 Timer

[puneethj]

Posted on November 10, 2015 at 17:34

Hello every one! How can i check if the timer is already running.. which flag to use I am trying this

if (TIM2 -> CR1 == TIM_CR1_CEN){// turn led on blue} else{// turn led red on}but it does not work, please help me #!stm32f4-disco #discovery #stm32f4 #timers

[Tesla DeLorean]

Posted on November 10, 2015 at 18:56

I'd presume it's looking for a bit level mask, not a comparison.

[puneethj]

Posted on November 10, 2015 at 19:11

I dont know, but my task is to check if the timer is enabled or disabled. Please tell me how can i do that

[Tesla DeLorean]

Posted on November 10, 2015 at 19:17

It's a bit, mask it and check if it's zero or not

if (TIM2->CR1 & TIM_CR1_CEN) // test the enable BIT
{
// turn led on blue
} 
else
{
// turn led red on
}

[ftiti]

Posted on November 10, 2015 at 19:21

Hello,

I have a solution proposal: You can set an Update event by Software juste before enabling the timer ( timer when enabled it will generate an UEV )   /* Set th UG bit to enable UEV */   TIM1->EGR |= TIM_EGR_UG; Then, you should manage by reading the UIF (update interrupt flag)  and cheking if it's set : if ( (TIM2 -> SR & TIM_SR_UIF) != RESET ) { // turn led on blue } else { // turn led red on } Good luck

[puneethj]

Posted on November 10, 2015 at 19:28

The problem with Update interrupt flag is it is always triggered even when the timer is not started. 

[ftiti]

Posted on November 11, 2015 at 13:06 Yes, I see. Since UDIS and URS bit in TIM_CR1 are reset by defaut, by enabling the timer an UEV is automatically generated and thus the UIF bit is set . So it beacomes more easy for your case and you can directly check if the timer is enabled or not through the UIF bit status: if ( (TIM2 -> SR & TIM_SR_UIF) != RESET ) { // turn led on blue } else { // turn led red on }