Please suggest me STM32 CAN2.0 board

[Akshay Bhavsar]

Posted on March 01, 2018 at 09:08

I need to select CAN 2.0 controller in my application.I would like to get low cost evaluation board for the same.

Please suggest me STM32 CAN2.0 board so that I can learn CAN.

[Akshay Bhavsar]

Posted on March 01, 2018 at 09:15

http://www.st.com/en/microcontrollers/stm32f429zi.html

board is there but it has LCD.I don't have to use LCD in my app.

[Imen.D]

Posted on March 01, 2018 at 10:52

Hello

akshaybhavsar30

,

I recommend you to use the '

http://www.st.com/content/st_com/en/products/development-tools/software-development-tools/stm32-software-development-tools/stm32-utilities/st-mcu-finder.html

' tool , it will help you to find the

STM32 microcontrollers which may answer your request.

Best Regards

Imen

[Akshay Bhavsar]

Posted on March 01, 2018 at 11:11

I dont have to select controller.Controller that i select may not have evaluation board.rather i would select evaluation board having CAN,I2C,SPI interfcace

[Tesla DeLorean]

Posted on March 01, 2018 at 14:55

You don't have to use the LCD unless you need too. The STM32F429I-DISCO is probably a poor choice for other reasons, including the lack of pins in escape other interfaces. The Nucleo-144 boards offer more opportunity to add your own circuitry and interfaces.

ST's EVAL series boards provide CAN interface(s)

This board using the F107 provides for two

https://www.ebay.com/itm/STM32-ARM-Cortex-M3-STM32F107VCT6-Development-Board/172257169142

 

as does the

https://www.ebay.com/itm/RedDragon407-STM32F4-Cortex-M4-3-2-Ethernet-wireless-2-4G-SDIO-Serial-camera/121087293812

 

[Akshay Bhavsar]

Posted on March 01, 2018 at 15:24

Does cortex m3 board has debugger on board?

[Tesla DeLorean]

Posted on March 01, 2018 at 15:32

Both cited boards have a 20-pin JTAG connector, you'll need to use an external pod, either a stand-alone ST-LINK, or pin wiring to one onboard a DISCO or NUCLEO board.

[Akshay Bhavsar]

Posted on March 01, 2018 at 15:36

please send me link for ST link debugger

[Tesla DeLorean]

Posted on March 01, 2018 at 15:42

Could you try Google?

http://www.st.com/en/development-tools/st-link-v2.html

 

[Akshay Bhavsar]

Posted on March 02, 2018 at 07:38

i would prefer to get Nucleo-144 as having debugger on board.I have gone through them.Almost 20 types of nucleo-144 board are available.I need Ethernet  connector,USB,I2C,SPI,CAN.I have selected NUCLEO-F446ZE.But datasheet says ethernet connector is available depensing on STM32 support.What does that mean?