I have a "Electronic speed controller Discovery kit for drones with STM32G431CB" and I want to use the UART for custom I/O but the exposed UART pins on the edge of the board are connected between U6 and U8 and cannot be used by me. Is this true?

[GSeme.1]

I'm trying to use this board to develop the serial I/O "user interface" for my application but I don't have my custom board yet.

[Laurent Ca...]

Dear @GSeme.1​ 

Sorry for the late answer.

Do you have still this problem to solve?

And just in case, if not, do not hesitate to share the final solution you found. Thanks by advance.

Best regards

[GSeme.1]

I had to manually remove the ASPEP code and insert my code in it's place