Does the UCPD on G0x1 support DisplayPort Alt Mode?

[Nobody233]

As title says.

If so, where could I find an example.

If not, will it be supported?

[Nicolas P. · Accepted solution]

Hello @Nobody233 

All our STM32 that have UCPD IP inside support Alt Modes. You need to select the right USBPD library.

There is an available firmware demonstrating that on STM32G0 evaluation board.

Demo firmware is here in github. There is also a wiki here.

There also an another board steval-USBC2DP specially for this here.

Regards,

Nicolas

[Nobody233]

Hello @Nicolas P. 

Thanks for your reply.

It's really helpful, thank you again.

Best regards.